Bradco Factory kitchen designs using the Computer Beam Saw

Email

Our State-of-the-Art factory, equipped with the most up-to-date computerised machinery, combined with the skills of all our certified tradesmen.

The Computer Beam Saw is directly linked to the Production office.
The office downloads the information for panel cutting direct from the kitchen drawing.

Parts are then barcoded for control throughout the factory.

.
.............	Edge Bander edges panels in .4mm or 2mm PVC edge tape. Glue is first applied at 180°F and then the edgetape is applied using 5 pressure rollers.	..........

High Heat Resistant Glue is applied by spray gun before going to the Postformer to roll the edge.

Bench Tops are produced in the post forming section.

Sanding is done with air or electric machinery to achieve accuracy of the flat panel.

Lacquer is applied under controlled conditions in a pressurised dust free spray booth.

• The hinge inserter bores the hinge hole and presses the hinge into the door accurately.

• Parts are routed and bored accurately in a computer controlled point to point machining centre.

• Parts are identified by a Barcode produced from the beginning of the process at the Beam Saw.

Our products are finished off by Qualified Cabinetmakers.

...

Units are assembled from compound parts by our professional tradesmen and checked for quality.
When passed, a quality assurance label is placed on the article.

.....

Delivery of assembled units are carefully loaded and checked off the plan as they are loaded into our own trucks.
Units are installed by our own professionally trained tradesmen.
Quality assurance labels are applied on completion.